A few days ago, we showed you the internal and external characteristics of a great pair of wireless headphones, and they are the Edifier TWS1, which have managed to create their own great reputation. Because of that, today we decided to teach you how to use them, and all thanks to the much-needed Edifier TWS1 Manual. Stay with us so you can learn how to use them!
If you want to pair a single earphone to a device, you have to remove the earbud of choice from the charging case and follow the instructions for “Both earbuds pairing” shown above. If the steps were followed correctly, the earbud should connect successfully.
The left and right earbuds come with TWS sync from the factory. With that being said, in case they don’t connect, you have to follow the following steps to re-sync them:
To disconnect any smart device that is connected to the earbuds, make sure that it is not playing anything or that there is a telephone conversation, and then press and hold the touch panel of any of the earbuds for 5 seconds.
After having connected the headphones to the smart device of choice, the amount of operating options we have is minimal.
NOTE: Having said that, to clear the pairing records of the earbuds without TWS and Bluetooth connection, respectively, you have to press and hold the touch panel of any of the earbuds for 8 seconds.
When using the earbuds, if a red LED light starts to flash on them, it means that they are low on battery power. When that happens, plug the earbuds into the charging case, then turn on the charging case. In this way, the earbuds will start to charge automatically as long as the charging case has a battery. They have a charging time of approximately 1.5 hours.
If the LED light of the charging case flashes slowly, it means that the earbuds can be charged because it has enough battery, but if it flashes quickly, it means that the charging case is low on battery. When this happens, you have to charge the charging case immediately, because, if it does not have enough battery, the earbuds will not turn on.
NOTE: In case of not being used for a long time, it is recommended to charge the charging case with a lithium battery at least once every 3 months.
This means that the earbuds do not have enough battery to perform pairing or music playback, so they have to be placed in the charging case with enough battery.
In case this happens, the following must be done:
You have to check if the paired device supports AVRCP (Audio/Video Remote Control Profile).
NOTE: If the problems mentioned above continue to occur even if the instructions in the Edifier TWS1 Manual have been carried out, they must be sent to repair service.
We hope you now know how to operate the earphone from the above Edifier TWS1 Manual. Want to know anything about the earphones? Do not hesitate to ask in the comments section.